05-12-2012, 08:50 AM
(05-11-2012, 07:29 PM)Dave J Wrote: Not good news, I thought it may have been able to be used on yours as well. It takes that terrible rattle out.
If you install the spline in there do you have any room beside it for a thin one?
Dave
Dave,
Maybe .020" at most. Then I don't really have any rattling sounds when milling so I'm thinking your fix was for a different problem. The splines on my spindle have a fit that is a bit sloppy. If you rotate the spindle you can see there is a little bit of play in the mating of the male and female splines. See attached image.
Ed