|
shop made forklift?????????????
|
11-26-2014, 01:22 PM
The forks I made for the tractor are 4 inch channel with the flange cut down the length to taper them to a point at the tip, then welded 1/4 x 4 flat bar to the bottom. I've managed to bend the tips trying to lever rocks out of the ground or logs from a frozen pile but they work fine for the 1200 pound lift of the tractor.
Free advice is worth exactly what you payed for it.
Greg |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
shop made forklift????????????? - by Dr Stan - 11-25-2014, 12:50 PM
RE: shop made forklift????????????? - by TomG - 11-25-2014, 01:31 PM
RE: shop made forklift????????????? - by Dr Stan - 11-25-2014, 02:35 PM
RE: shop made forklift????????????? - by awemawson - 11-25-2014, 03:30 PM
RE: shop made forklift????????????? - by f350ca - 11-25-2014, 05:25 PM
RE: shop made forklift????????????? - by RobWilson - 11-26-2014, 11:51 AM
RE: shop made forklift????????????? - by f350ca - 11-26-2014, 01:22 PM
RE: shop made forklift????????????? - by Dr Stan - 11-27-2014, 11:28 AM
RE: shop made forklift????????????? - by RobWilson - 11-27-2014, 11:39 AM
RE: shop made forklift????????????? - by Dr Stan - 11-27-2014, 11:51 AM
RE: shop made forklift????????????? - by EdK - 11-27-2014, 04:23 PM
RE: shop made forklift????????????? - by RobWilson - 11-27-2014, 12:09 PM
RE: shop made forklift????????????? - by Dr Stan - 11-30-2014, 11:46 PM
|
