11-25-2014, 03:30 PM
A bit of back tilt on the forks once the load is engaged would be a huge advantage.
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
|
shop made forklift?????????????
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
shop made forklift????????????? - by Dr Stan - 11-25-2014, 12:50 PM
RE: shop made forklift????????????? - by TomG - 11-25-2014, 01:31 PM
RE: shop made forklift????????????? - by Dr Stan - 11-25-2014, 02:35 PM
RE: shop made forklift????????????? - by awemawson - 11-25-2014, 03:30 PM
RE: shop made forklift????????????? - by f350ca - 11-25-2014, 05:25 PM
RE: shop made forklift????????????? - by RobWilson - 11-26-2014, 11:51 AM
RE: shop made forklift????????????? - by f350ca - 11-26-2014, 01:22 PM
RE: shop made forklift????????????? - by Dr Stan - 11-27-2014, 11:28 AM
RE: shop made forklift????????????? - by RobWilson - 11-27-2014, 11:39 AM
RE: shop made forklift????????????? - by Dr Stan - 11-27-2014, 11:51 AM
RE: shop made forklift????????????? - by EdK - 11-27-2014, 04:23 PM
RE: shop made forklift????????????? - by RobWilson - 11-27-2014, 12:09 PM
RE: shop made forklift????????????? - by Dr Stan - 11-30-2014, 11:46 PM
|
Users browsing this thread: 2 Guest(s)