MetalworkingFun Forum › Machinery › Milling Machines v
A fix for bad fitting splines in Chinese mills

Thread Modes
A fix for bad fitting splines in Chinese mills
Dave J Offline
Sophmore
***
Posts: 183
Threads: 22
Joined: Feb 2012
Location: Australia
#5
05-11-2012, 07:29 PM
Not good news, I thought it may have been able to be used on yours as well. It takes that terrible rattle out.

If you install the spline in there do you have any room beside it for a thin one?

Dave
Reply
Thanks given by:


Messages In This Thread
RE: A fix for bad fitting splines in Chinese mills - by Dave J - 05-11-2012, 07:29 PM
RE: A fix for bad fitting splines in Chinese mills - by bert59 - 07-13-2012, 12:20 PM
RE: A fix for bad fitting splines in Chinese mills - by bert59 - 07-13-2012, 03:46 PM



Users browsing this thread: 2 Guest(s)