11-20-2014, 10:53 AM
(This post was last modified: 11-20-2014, 11:02 AM by Dr Stan.
Edit Reason: another thought
)
Tom,
Very nice design & drawings.
I especially like removing the stress from the cross slide.
What is the largest diameter it is designed to knurl?
One comment/suggestion. I'd add the 10-32 bolt hole pattern on the back/bottom of the holder which would enable one to mount it 90 degrees from the existing design. I think it would give the knurler more options for mounting and probably reduce tailstock extension making the set-up more rigid. That would be especially advantageous to those with smaller (< 10") lathes.
Thanks,
Stan
Very nice design & drawings.
I especially like removing the stress from the cross slide.What is the largest diameter it is designed to knurl?
One comment/suggestion. I'd add the 10-32 bolt hole pattern on the back/bottom of the holder which would enable one to mount it 90 degrees from the existing design. I think it would give the knurler more options for mounting and probably reduce tailstock extension making the set-up more rigid. That would be especially advantageous to those with smaller (< 10") lathes.
Thanks,
Stan