|
My birthday vise
|
11-15-2014, 03:17 AM
This is what I had to deal with on the vice I got from busy bee tools. The first two pics show the same piece of key stock in both slots, the last is just the original key. I had to mill the slots square and make a new key with a step to accommodate the new wider slot on the base and original slot in the fixed jaw
![[Image: image.jpg]](http://s10.postimg.org/tpg1zugqd/image.jpg) ![[Image: image.jpg]](http://s10.postimg.org/w5hvdoyt1/image.jpg) ![[Image: image.jpg]](http://s10.postimg.org/yyb2xpz5h/image.jpg)
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
My birthday vise - by JScott - 10-28-2014, 01:26 PM
RE: My birthday vise - by Highpower - 10-28-2014, 03:47 PM
RE: My birthday vise - by EdK - 10-28-2014, 04:07 PM
RE: My birthday vise - by doubleboost - 10-28-2014, 07:10 PM
RE: My birthday vise - by kenne - 10-28-2014, 08:03 PM
RE: My birthday vise - by JScott - 10-29-2014, 10:55 AM
RE: My birthday vise - by Shawn - 10-29-2014, 11:03 AM
RE: My birthday vise - by JScott - 10-30-2014, 10:20 AM
RE: My birthday vise - by Dr Stan - 10-30-2014, 12:25 PM
RE: My birthday vise - by JScott - 10-30-2014, 12:43 PM
RE: My birthday vise - by PixMan - 10-30-2014, 09:36 PM
RE: My birthday vise - by JScott - 11-10-2014, 01:48 PM
RE: My birthday vise - by PixMan - 11-10-2014, 04:18 PM
RE: My birthday vise - by Shawn - 11-15-2014, 03:17 AM
|
