MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tools help - buying advice

Thread Modes
Tools help - buying advice
ironman Offline
Freshman
**
Posts: 38
Threads: 4
Joined: Apr 2014
Location: Norway
#18
11-14-2014, 10:03 AM
Im looking around for tool bit holders. Are there different sizes on the bits itself?
The ones i have today is from KOMET. Here are some of the numbers that are on the boxes:
P1-R-P25
P1-K20 N
P1-L-P25

What does the numbers say?
ironman, proud to be a member of MetalworkingFun Forum since Apr 2014.
Reply
Thanks given by:


Messages In This Thread
Tools help - buying advice - by ironman - 11-13-2014, 08:22 AM
RE: Tools help - buying advice - by Dr Stan - 11-13-2014, 02:58 PM
RE: Tools help - buying advice - by ironman - 11-13-2014, 03:28 PM
RE: Tools help - buying advice - by DaveH - 11-13-2014, 04:05 PM
RE: Tools help - buying advice - by Mayhem - 11-13-2014, 05:34 PM
RE: Tools help - buying advice - by TomG - 11-13-2014, 08:33 PM
RE: Tools help - buying advice - by PixMan - 11-13-2014, 09:41 PM
RE: Tools help - buying advice - by Mayhem - 11-14-2014, 04:58 AM
RE: Tools help - buying advice - by arvidj - 11-14-2014, 08:50 AM
RE: Tools help - buying advice - by Dr Stan - 11-13-2014, 11:09 PM
RE: Tools help - buying advice - by ironman - 11-14-2014, 03:44 AM
RE: Tools help - buying advice - by Highpower - 11-14-2014, 06:07 AM
RE: Tools help - buying advice - by EdK - 11-14-2014, 06:22 AM
RE: Tools help - buying advice - by svk - 11-14-2014, 07:21 AM
RE: Tools help - buying advice - by Mayhem - 11-14-2014, 07:30 AM
RE: Tools help - buying advice - by stevec - 11-14-2014, 07:35 AM
RE: Tools help - buying advice - by ironman - 11-14-2014, 08:06 AM
RE: Tools help - buying advice - by ironman - 11-14-2014, 10:03 AM
RE: Tools help - buying advice - by DaveH - 11-14-2014, 12:34 PM



Users browsing this thread: 1 Guest(s)