Between centers boring bar

Thread Modes

Between centers boring bar

chucketn Offline

Junior

Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN

The following 3 users Like chucketn's post:
Mayhem (11-07-2014), Highpower (11-07-2014), DaveH (11-08-2014)

#21

11-07-2014, 05:19 PM

Thanks, John. I have saved all your videos on the DH, and am trying my best to emulate your work. Just run into snags now and then. I will bore the body and turn the spindle to fit.
BTW, thanks again for your great videos and down to earth sense of humor. Your Sunday Nite Nightcaps are the highlight of my week...

Chuck

Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

Between centers boring bar - by chucketn - 11-06-2014, 09:23 AM

RE: Between centers boring bar - by JScott - 11-06-2014, 09:38 AM

RE: Between centers boring bar - by chucketn - 11-06-2014, 09:48 AM

RE: Between centers boring bar - by f350ca - 11-06-2014, 09:59 AM

RE: Between centers boring bar - by chucketn - 11-06-2014, 10:09 AM

RE: Between centers boring bar - by f350ca - 11-06-2014, 10:27 AM

RE: Between centers boring bar - by Lordedmond - 11-06-2014, 10:31 AM

RE: Between centers boring bar - by dallen - 11-06-2014, 10:34 AM