MetalworkingFun Forum › Machining › General Metalworking Discussion v
Between centers boring bar

Thread Modes
Between centers boring bar
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#19
11-07-2014, 12:42 PM
What is the length/depth of the hole?

What is the finished diameter?

What precision is needed?

What is the material?

Do you have a boring head that can be mounted in the head stock?

What sort of selection of single ended end mills do you have?
Reply
Thanks given by:


Messages In This Thread
Between centers boring bar - by chucketn - 11-06-2014, 09:23 AM
RE: Between centers boring bar - by JScott - 11-06-2014, 09:38 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 09:48 AM
RE: Between centers boring bar - by f350ca - 11-06-2014, 09:59 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 10:09 AM
RE: Between centers boring bar - by f350ca - 11-06-2014, 10:27 AM
RE: Between centers boring bar - by Lordedmond - 11-06-2014, 10:31 AM
RE: Between centers boring bar - by dallen - 11-06-2014, 10:34 AM
RE: Between centers boring bar - by EdK - 11-06-2014, 11:04 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 11:54 AM
RE: Between centers boring bar - by TomG - 11-06-2014, 12:51 PM
RE: Between centers boring bar - by chucketn - 11-06-2014, 01:10 PM
RE: Between centers boring bar - by TomG - 11-06-2014, 02:44 PM
RE: Between centers boring bar - by doubleboost - 11-06-2014, 01:07 PM
RE: Between centers boring bar - by Lordedmond - 11-06-2014, 01:21 PM
RE: Between centers boring bar - by Dr Stan - 11-06-2014, 10:19 PM
RE: Between centers boring bar - by chucketn - 11-07-2014, 06:49 AM
RE: Between centers boring bar - by stevec - 11-07-2014, 07:33 AM
RE: Between centers boring bar - by Dr Stan - 11-07-2014, 12:42 PM
RE: Between centers boring bar - by doubleboost - 11-07-2014, 12:45 PM
RE: Between centers boring bar - by chucketn - 11-07-2014, 05:19 PM
RE: Between centers boring bar - by Hopefuldave - 11-09-2014, 08:17 AM



Users browsing this thread: 9 Guest(s)