MetalworkingFun Forum › Machining › General Metalworking Discussion v
Between centers boring bar

Thread Modes
Between centers boring bar
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#17
11-07-2014, 06:49 AM
(11-06-2014, 10:19 PM)Dr Stan Wrote: A half inch boring bar is quite small and can lead to chatter & flex.  Is that the largest bar that will fit in the hole?

Yes, the largest long drill I have is 1/2" MT1. I'm looking for a few bigger ones that are affordable.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Between centers boring bar - by chucketn - 11-06-2014, 09:23 AM
RE: Between centers boring bar - by JScott - 11-06-2014, 09:38 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 09:48 AM
RE: Between centers boring bar - by f350ca - 11-06-2014, 09:59 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 10:09 AM
RE: Between centers boring bar - by f350ca - 11-06-2014, 10:27 AM
RE: Between centers boring bar - by Lordedmond - 11-06-2014, 10:31 AM
RE: Between centers boring bar - by dallen - 11-06-2014, 10:34 AM
RE: Between centers boring bar - by EdK - 11-06-2014, 11:04 AM
RE: Between centers boring bar - by chucketn - 11-06-2014, 11:54 AM
RE: Between centers boring bar - by TomG - 11-06-2014, 12:51 PM
RE: Between centers boring bar - by chucketn - 11-06-2014, 01:10 PM
RE: Between centers boring bar - by TomG - 11-06-2014, 02:44 PM
RE: Between centers boring bar - by doubleboost - 11-06-2014, 01:07 PM
RE: Between centers boring bar - by Lordedmond - 11-06-2014, 01:21 PM
RE: Between centers boring bar - by Dr Stan - 11-06-2014, 10:19 PM
RE: Between centers boring bar - by chucketn - 11-07-2014, 06:49 AM
RE: Between centers boring bar - by stevec - 11-07-2014, 07:33 AM
RE: Between centers boring bar - by Dr Stan - 11-07-2014, 12:42 PM
RE: Between centers boring bar - by doubleboost - 11-07-2014, 12:45 PM
RE: Between centers boring bar - by chucketn - 11-07-2014, 05:19 PM
RE: Between centers boring bar - by Hopefuldave - 11-09-2014, 08:17 AM



Users browsing this thread: 4 Guest(s)