11-06-2014, 01:21 PM
Sorry Tom
But it will not be a problem ,take cut measure the bore , Mike the cutter from the the back of the bar and adjust as required
The cutter in a bent bar is considered a fixed point , therefor the required adjustment is easily done
Stuart
But it will not be a problem ,take cut measure the bore , Mike the cutter from the the back of the bar and adjust as required
The cutter in a bent bar is considered a fixed point , therefor the required adjustment is easily done
Stuart
Lordedmond, proud to be a member of MetalworkingFun Forum since Jul 2013.