11-06-2014, 01:10 PM
(11-06-2014, 12:51 PM)TomG Wrote: The only case where runout would matter is if you are setting the diameter by miking over the bar and tool. If the bar has runout it would give you a false reading.
Tom
Well, if the bar has runout, how do you set the bore diameter? Trial and error?
I'm going to try to make another between centers bar, this time from 1/2" drill rod.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.