11-06-2014, 10:31 AM
It matters not a jot
The tool bit is excentric anyway , the tool tip care not if the bar dose not run true , it will still follow a circular path thus bore a true hole
There was a design that used a sliding dovetail arangmet to make the bar wobble this was to provide a fine adjustment of the cutter
Stuart
The tool bit is excentric anyway , the tool tip care not if the bar dose not run true , it will still follow a circular path thus bore a true hole
There was a design that used a sliding dovetail arangmet to make the bar wobble this was to provide a fine adjustment of the cutter
Stuart
Lordedmond, proud to be a member of MetalworkingFun Forum since Jul 2013.