05-11-2012, 10:03 AM
And here is a bit more detail
The base is made of 6 pieces, the base which is a piece of 10mm from memory, the 6 triangle pieces and the top cap. I just tacked them up from the inside which was a bit of a mission with the 350 amp mig gun nozzle LOL, then used the die grinder to knock the weld down a bit.
For the wires to get though I drilled 10mm hole which allows enough room for the wires to get past the 6mm bolt.
This piece below was made out of 3 pieces and the 2 squares where machined and drill before cutting the angles on them. The wire only needed to be light because the LED doesn't draw much power.
Dave
The base is made of 6 pieces, the base which is a piece of 10mm from memory, the 6 triangle pieces and the top cap. I just tacked them up from the inside which was a bit of a mission with the 350 amp mig gun nozzle LOL, then used the die grinder to knock the weld down a bit.
For the wires to get though I drilled 10mm hole which allows enough room for the wires to get past the 6mm bolt.
This piece below was made out of 3 pieces and the 2 squares where machined and drill before cutting the angles on them. The wire only needed to be light because the LED doesn't draw much power.
Dave