MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
My birthday vise

Thread Modes
My birthday vise
Dr Stan Offline
Senior
*****
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
#9
10-30-2014, 12:25 PM
Ditto on the keeper as my wife also buys me tools. When you store the base spray it down with LPS3 or spread a good coat of grease on the bare surfaces. Wrap it in wax paper, or better yet oil cloth if you can find the real stuff.
Reply
Thanks given by:


Messages In This Thread
My birthday vise - by JScott - 10-28-2014, 01:26 PM
RE: My birthday vise - by Highpower - 10-28-2014, 03:47 PM
RE: My birthday vise - by EdK - 10-28-2014, 04:07 PM
RE: My birthday vise - by doubleboost - 10-28-2014, 07:10 PM
RE: My birthday vise - by kenne - 10-28-2014, 08:03 PM
RE: My birthday vise - by JScott - 10-29-2014, 10:55 AM
RE: My birthday vise - by Shawn - 10-29-2014, 11:03 AM
RE: My birthday vise - by JScott - 10-30-2014, 10:20 AM
RE: My birthday vise - by Dr Stan - 10-30-2014, 12:25 PM
RE: My birthday vise - by JScott - 10-30-2014, 12:43 PM
RE: My birthday vise - by PixMan - 10-30-2014, 09:36 PM
RE: My birthday vise - by JScott - 11-10-2014, 01:48 PM
RE: My birthday vise - by PixMan - 11-10-2014, 04:18 PM
RE: My birthday vise - by Shawn - 11-15-2014, 03:17 AM



Users browsing this thread: 3 Guest(s)