|
Fly cutter project!!!
|
05-11-2012, 07:02 AM
(05-10-2012, 04:25 PM)pjf134 Wrote: , so I put a piece of 3/4" dia. cold rolled in the lathe and turned down the shaft to fit the mill holder.Just curious as to why the shank seems so small (dia.). Is that the largest end mill holder you have? I'm not criticizing, just thought the biggest shank possible would be best.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Fly cutter project!!! - by pjf134 - 05-10-2012, 04:25 PM
RE: Fly cutter project!!! - by DaveH - 05-10-2012, 05:12 PM
RE: Fly cutter project!!! - by EdK - 05-10-2012, 06:05 PM
RE: Fly cutter project!!! - by Highpower - 05-10-2012, 08:21 PM
RE: Fly cutter project!!! - by pjf134 - 05-10-2012, 10:16 PM
RE: Fly cutter project!!! - by Dave J - 05-11-2012, 12:28 AM
RE: Fly cutter project!!! - by stevec - 05-11-2012, 07:02 AM
RE: Fly cutter project!!! - by pjf134 - 05-11-2012, 08:28 AM
RE: Fly cutter project!!! - by doubleboost - 05-11-2012, 04:59 PM
RE: Fly cutter project!!! - by aametalmaster - 05-11-2012, 08:18 PM
RE: Fly cutter project!!! - by dallen - 05-11-2012, 09:49 PM
RE: Fly cutter project!!! - by pjf134 - 05-11-2012, 10:27 PM
|
