10-27-2014, 03:59 PM
Not a lot done today, been at the Doc's all morning.
Started on the camshaft gear
Turning the blank. I can even turn the back of the blank now after modifying the 7x12 ??
Taking the first cut on the mill. note how blueing the edge helps.
that's all for today
Brian
Started on the camshaft gear
Turning the blank. I can even turn the back of the blank now after modifying the 7x12 ??
Taking the first cut on the mill. note how blueing the edge helps.
that's all for today
Brian
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com
http://briansworkshop.weebly.com