Flywheel pattern making
#5
(10-25-2014, 07:43 PM)texx Wrote: bit tough to explain in writting . but you need to center your r/t then off set it from center the correct amout on one axis then turn the table so you are on one edge of a spoke say left edge then with your other axis cut every left edge , then return r/t to center and then offest for the right edge and machine all the right edges of the spokes . there ya go clear as mud.
i could show you but i cant put it in writting very well .

johno

Got it, Johno. Thanks.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Flywheel pattern making - by chucketn - 10-25-2014, 11:47 AM
RE: Flywheel pattern making - by dallen - 10-25-2014, 01:15 PM
RE: Flywheel pattern making - by f350ca - 10-25-2014, 01:23 PM
RE: Flywheel pattern making - by texx - 10-25-2014, 07:43 PM
RE: Flywheel pattern making - by chucketn - 10-26-2014, 06:33 AM
RE: Flywheel pattern making - by Dr Stan - 11-06-2014, 10:21 PM
RE: Flywheel pattern making - by chucketn - 11-07-2014, 06:46 AM
RE: Flywheel pattern making - by Dr Stan - 11-16-2014, 07:22 PM



Users browsing this thread: 3 Guest(s)