Flywheel pattern making
#4
bit tough to explain in writting . but you need to center your r/t then off set it from center the correct amout on one axis then turn the table so you are on one edge of a spoke say left edge then with your other axis cut every left edge , then return r/t to center and then offest for the right edge and machine all the right edges of the spokes . there ya go clear as mud.
i could show you but i cant put it in writting very well .

johno
texx, proud to be a member of MetalworkingFun Forum since May 2014.
Reply
Thanks given by:


Messages In This Thread
Flywheel pattern making - by chucketn - 10-25-2014, 11:47 AM
RE: Flywheel pattern making - by dallen - 10-25-2014, 01:15 PM
RE: Flywheel pattern making - by f350ca - 10-25-2014, 01:23 PM
RE: Flywheel pattern making - by texx - 10-25-2014, 07:43 PM
RE: Flywheel pattern making - by chucketn - 10-26-2014, 06:33 AM
RE: Flywheel pattern making - by Dr Stan - 11-06-2014, 10:21 PM
RE: Flywheel pattern making - by chucketn - 11-07-2014, 06:46 AM
RE: Flywheel pattern making - by Dr Stan - 11-16-2014, 07:22 PM



Users browsing this thread: 2 Guest(s)