Round HSS inserts

Thread Modes

Round HSS inserts

chucketn Offline

Junior

Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN

10-25-2014, 07:28 PM

(10-25-2014, 06:45 PM)dallen Wrote: what diameter are you looking for

If I read the spec correctly, the inserts are 10mm with 4mm hole for the screw.

Insert here: http://www.ctctools.biz/servlet/the-721/...ING/Detail

tool holder here: http://www.ctctools.biz/servlet/the-611/...the/Detail

Chuck

Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.

« Next Oldest | Next Newest »

Messages In This Thread

Round HSS inserts - by chucketn - 10-25-2014, 04:00 PM

RE: Round HSS inserts - by Dr Stan - 10-25-2014, 05:04 PM

RE: Round HSS inserts - by dallen - 10-25-2014, 06:45 PM

RE: Round HSS inserts - by chucketn - 10-25-2014, 07:28 PM

RE: Round HSS inserts - by dallen - 10-25-2014, 08:32 PM

RE: Round HSS inserts - by dallen - 10-26-2014, 08:15 AM

RE: Round HSS inserts - by chipist - 10-26-2014, 01:00 PM

RE: Round HSS inserts - by Dr Stan - 10-26-2014, 10:25 PM

RE: Round HSS inserts - by PixMan - 10-27-2014, 06:31 AM

Users browsing this thread: 1 Guest(s)