Flywheel pattern making
#2
no drawing but you will probably have to off set your tailstock

sorry found drawing someplace else, you can do it on the rotary table you will just have to get things aligned or take out as much as you can then file to the line
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Flywheel pattern making - by chucketn - 10-25-2014, 11:47 AM
RE: Flywheel pattern making - by dallen - 10-25-2014, 01:15 PM
RE: Flywheel pattern making - by f350ca - 10-25-2014, 01:23 PM
RE: Flywheel pattern making - by texx - 10-25-2014, 07:43 PM
RE: Flywheel pattern making - by chucketn - 10-26-2014, 06:33 AM
RE: Flywheel pattern making - by Dr Stan - 11-06-2014, 10:21 PM
RE: Flywheel pattern making - by chucketn - 11-07-2014, 06:46 AM
RE: Flywheel pattern making - by Dr Stan - 11-16-2014, 07:22 PM



Users browsing this thread: 2 Guest(s)