10-23-2014, 06:39 AM
David,
Now I see what you were doing. That pocket was probably cast in the original, but I would probably approximate it with a small end mill going in from the side. It wouldn't take much to clear that link. A small corner radius would also be good to keep it from cracking at during heat treat.
Tom
Now I see what you were doing. That pocket was probably cast in the original, but I would probably approximate it with a small end mill going in from the side. It wouldn't take much to clear that link. A small corner radius would also be good to keep it from cracking at during heat treat.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)