MetalworkingFun Forum › Machining › General Metalworking Discussion v
Edge Finder Disassembly

Thread Modes
Edge Finder Disassembly
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#6
10-19-2014, 12:14 PM
Well I just ended up applying some light oil to the sliding surfaces to get me through this job and it worked just fine. I think I'll soak it overnight in some denatured alcohol and then give it a good cleaning tomorrow followed by oiling.

Ed
Reply
Thanks given by:


Messages In This Thread
Edge Finder Disassembly - by EdK - 10-19-2014, 08:43 AM
RE: Edge Finder Disassembly - by Mayhem - 10-19-2014, 09:01 AM
RE: Edge Finder Disassembly - by EdK - 10-19-2014, 09:09 AM
RE: Edge Finder Disassembly - by dallen - 10-19-2014, 10:23 AM
RE: Edge Finder Disassembly - by Highpower - 10-19-2014, 10:31 AM
RE: Edge Finder Disassembly - by EdK - 10-19-2014, 12:14 PM
RE: Edge Finder Disassembly - by f350ca - 10-19-2014, 12:39 PM
RE: Edge Finder Disassembly - by EdK - 10-19-2014, 03:31 PM
RE: Edge Finder Disassembly - by stevec - 01-18-2015, 08:23 AM
RE: Edge Finder Disassembly - by arvidj - 01-18-2015, 09:19 AM
RE: Edge Finder Disassembly - by Tony Wells - 01-18-2015, 02:48 AM
RE: Edge Finder Disassembly - by Arbalest - 01-18-2015, 06:34 AM
RE: Edge Finder Disassembly - by DaveH - 01-18-2015, 09:40 AM
RE: Edge Finder Disassembly - by Hawkeye - 01-18-2015, 07:44 PM
RE: Edge Finder Disassembly - by TomG - 01-18-2015, 08:15 PM
RE: Edge Finder Disassembly - by DaveH - 01-19-2015, 07:46 AM
RE: Edge Finder Disassembly - by Highpower - 01-19-2015, 09:49 AM
RE: Edge Finder Disassembly - by Mayhem - 01-19-2015, 08:32 AM
RE: Edge Finder Disassembly - by Bill Gruby - 01-19-2015, 10:15 AM
RE: Edge Finder Disassembly - by Bill Gruby - 01-19-2015, 08:51 AM
RE: Edge Finder Disassembly - by mcostello - 01-19-2015, 12:44 PM
RE: Edge Finder Disassembly - by Baron - 02-15-2015, 04:39 PM



Users browsing this thread: 4 Guest(s)