10-19-2014, 10:21 AM
Willie look at it this way it may be a hobby saw but guns are your hobby.
I understand what your saying I can't drill a 3/32 hole thru a 6 inch long hunk of D2 and keep it on center,
Put some tape around the stock where your going to cut then take the saw and work in short sections and cut a shallow groove all the way around the stock and when you use the miter say it won't chip out, you really only need to do the side the blades going to be pulling out on, but by going all the way around you have a nice can't get rubbed off line for sanding too.
DA
I understand what your saying I can't drill a 3/32 hole thru a 6 inch long hunk of D2 and keep it on center,
Put some tape around the stock where your going to cut then take the saw and work in short sections and cut a shallow groove all the way around the stock and when you use the miter say it won't chip out, you really only need to do the side the blades going to be pulling out on, but by going all the way around you have a nice can't get rubbed off line for sanding too.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!