10-18-2014, 07:01 PM
Dave,
That was my first thought also but the vise jaws are only about 1.5" tall and if I space the workpiece up from the vise so I can mill through the two walls, there's not much vise jaw left holding the 3.25" diameter workpiece. That doesn't seem like it would be a very stout setup.
Ed
That was my first thought also but the vise jaws are only about 1.5" tall and if I space the workpiece up from the vise so I can mill through the two walls, there's not much vise jaw left holding the 3.25" diameter workpiece. That doesn't seem like it would be a very stout setup.
Ed