MetalworkingFun Forum › Machining › General Metalworking Discussion v
Question for the mates in the UK.

Thread Modes
Question for the mates in the UK.
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#19
10-11-2014, 06:47 AM
Aside from facing I've run into problems just turning a smaller diameter due to toolholder size.

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Question for the mates in the UK. - by Highpower - 09-09-2014, 11:31 PM
RE: Question for the mates in the UK. - by EdK - 09-10-2014, 10:47 AM
RE: Question for the mates in the UK. - by EdK - 09-15-2014, 04:01 PM
RE: Question for the mates in the UK. - by EdK - 09-16-2014, 03:31 PM
Update and another question.... - by Highpower - 10-09-2014, 09:33 PM
RE: Question for the mates in the UK. - by dallen - 10-09-2014, 09:47 PM
RE: Question for the mates in the UK. - by EdK - 10-10-2014, 05:17 AM
RE: Question for the mates in the UK. - by arvidj - 10-10-2014, 06:07 PM
RE: Question for the mates in the UK. - by Mayhem - 10-10-2014, 06:52 PM
RE: Question for the mates in the UK. - by stevec - 10-11-2014, 06:47 AM
RE: Question for the mates in the UK. - by EdK - 10-11-2014, 09:04 AM
RE: Question for the mates in the UK. - by arvidj - 10-11-2014, 08:33 AM
RE: Question for the mates in the UK. - by stevec - 10-12-2014, 06:55 AM



Users browsing this thread: 5 Guest(s)