MetalworkingFun Forum › Machining › Projects v
Atlas TH54

Thread Modes
Atlas TH54
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#8
10-10-2014, 06:57 PM
(10-10-2014, 08:36 AM)schor Wrote: Thanks for the comment. Babbit bearings make the job easier, but I wonder in the end will having to re-pour the bearings eventually be the down side.

Not at the speed that my lathe runs!
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Atlas TH54 - by schor - 10-09-2014, 11:18 AM
RE: Atlas TH54 - by EdK - 10-09-2014, 11:39 AM
RE: Atlas TH54 - by schor - 10-09-2014, 11:41 PM
RE: Atlas TH54 - by Mayhem - 10-10-2014, 07:56 AM
RE: Atlas TH54 - by dallen - 10-10-2014, 08:15 AM
RE: Atlas TH54 - by schor - 10-10-2014, 08:21 AM
RE: Atlas TH54 - by schor - 10-10-2014, 08:36 AM
RE: Atlas TH54 - by Mayhem - 10-10-2014, 06:57 PM
RE: Atlas TH54 - by schor - 10-11-2014, 08:57 PM
RE: Atlas TH54 - by krv3000 - 10-12-2014, 06:49 PM
RE: Atlas TH54 - by krv3000 - 10-14-2014, 06:22 PM
RE: Atlas TH54 - by schor - 10-14-2014, 10:51 PM



Users browsing this thread: 1 Guest(s)