MetalworkingFun Forum › Machining › General Metalworking Discussion v
Question for the mates in the UK.

Thread Modes
Question for the mates in the UK.
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#17
10-10-2014, 06:52 PM
With a half tip you can face right up to the centre of the part.
Hunting American dentists since 2015.
Reply
Thanks given by: arvidj


Messages In This Thread
Question for the mates in the UK. - by Highpower - 09-09-2014, 11:31 PM
RE: Question for the mates in the UK. - by EdK - 09-10-2014, 10:47 AM
RE: Question for the mates in the UK. - by EdK - 09-15-2014, 04:01 PM
RE: Question for the mates in the UK. - by EdK - 09-16-2014, 03:31 PM
Update and another question.... - by Highpower - 10-09-2014, 09:33 PM
RE: Question for the mates in the UK. - by dallen - 10-09-2014, 09:47 PM
RE: Question for the mates in the UK. - by EdK - 10-10-2014, 05:17 AM
RE: Question for the mates in the UK. - by arvidj - 10-10-2014, 06:07 PM
RE: Question for the mates in the UK. - by Mayhem - 10-10-2014, 06:52 PM
RE: Question for the mates in the UK. - by stevec - 10-11-2014, 06:47 AM
RE: Question for the mates in the UK. - by EdK - 10-11-2014, 09:04 AM
RE: Question for the mates in the UK. - by arvidj - 10-11-2014, 08:33 AM
RE: Question for the mates in the UK. - by stevec - 10-12-2014, 06:55 AM



Users browsing this thread: 13 Guest(s)