MetalworkingFun Forum › Machining › General Metalworking Discussion v
Question for the mates in the UK.

Thread Modes
Question for the mates in the UK.
arvidj Offline
Junior
****
Posts: 736
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
#16
10-10-2014, 06:07 PM
The neophyte question ... What is the advantage of only half a tip? I am guessing it is related to lubrication but that is based on thin air.
Reply
Thanks given by:


Messages In This Thread
Question for the mates in the UK. - by Highpower - 09-09-2014, 11:31 PM
RE: Question for the mates in the UK. - by EdK - 09-10-2014, 10:47 AM
RE: Question for the mates in the UK. - by EdK - 09-15-2014, 04:01 PM
RE: Question for the mates in the UK. - by EdK - 09-16-2014, 03:31 PM
Update and another question.... - by Highpower - 10-09-2014, 09:33 PM
RE: Question for the mates in the UK. - by dallen - 10-09-2014, 09:47 PM
RE: Question for the mates in the UK. - by EdK - 10-10-2014, 05:17 AM
RE: Question for the mates in the UK. - by arvidj - 10-10-2014, 06:07 PM
RE: Question for the mates in the UK. - by Mayhem - 10-10-2014, 06:52 PM
RE: Question for the mates in the UK. - by stevec - 10-11-2014, 06:47 AM
RE: Question for the mates in the UK. - by EdK - 10-11-2014, 09:04 AM
RE: Question for the mates in the UK. - by arvidj - 10-11-2014, 08:33 AM
RE: Question for the mates in the UK. - by stevec - 10-12-2014, 06:55 AM



Users browsing this thread: 12 Guest(s)