10-10-2014, 08:15 AM
most people don't know that a flat belt on a Lather or similar machine with a pulley setup such as on an atlas lathe can be installed without removing the spindle by simply gluing the joint and lacing it with flat lacing, no reason to remove the spindle to simply put on new belt, lots faster also. they also make fasteners for flat belts where all you do is slide in a pin.
also when switching from flat belt to a V-belt, you need to really watch the belt tension and not get it too tight which will cause undo wear on the babbit bearings/white metal. wide flat belts run lower belt tension the V-belts to deliver the same amount of power to the driven spindle.
also when switching from flat belt to a V-belt, you need to really watch the belt tension and not get it too tight which will cause undo wear on the babbit bearings/white metal. wide flat belts run lower belt tension the V-belts to deliver the same amount of power to the driven spindle.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!