MetalworkingFun Forum › Machining › Projects v
Lifting chucks and vises.

Thread Modes
Lifting chucks and vises.
f350ca Offline
Senior
*****
Posts: 3,003
Threads: 51
Joined: Apr 2012
Location: Ontario
#9
05-10-2012, 10:03 AM
Nice lifting gear. Need to build one for the mill vice and something for the rotary table. I made one for the lathe chucks, I used 1 inch rod with 1 inch pipe over it. This allows the chuck to rotate when alining the pins in the spindle.

Put two overhead cranes in the shop. They travel 36 feet down the shop, each 12 feet wide to cover the two bays. I had to put two posts in the middle of the shop to support the cabinet shop above.[Image: IMGP0824.jpg]
Greg
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:


Messages In This Thread
Lifting chucks and vises. - by Dave J - 05-10-2012, 03:07 AM
RE: Lifting chucks and vises. - by EdK - 05-10-2012, 06:19 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 06:54 AM
RE: Lifting chucks and vises. - by EdK - 05-10-2012, 06:59 AM
RE: Lifting chucks and vises. - by Mayhem - 05-10-2012, 07:03 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 07:59 AM
RE: Lifting chucks and vises. - by Mayhem - 05-10-2012, 08:14 AM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 09:21 AM
RE: Lifting chucks and vises. - by f350ca - 05-10-2012, 10:03 AM
RE: Lifting chucks and vises. - by Highpower - 05-10-2012, 03:28 PM
RE: Lifting chucks and vises. - by Dave J - 05-10-2012, 10:55 AM
RE: Lifting chucks and vises. - by doubleboost - 05-10-2012, 01:40 PM
RE: Lifting chucks and vises. - by DaveH - 05-10-2012, 02:10 PM
RE: Lifting chucks and vises. - by DaveH - 05-10-2012, 02:12 PM



Users browsing this thread: 1 Guest(s)