MetalworkingFun Forum › Machining › Metrology v
mick's D.T.I's refit

Thread Modes
mick's D.T.I's refit
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
The following 1 user Likes stevec's post:
EdK (10-01-2014)
#7
10-01-2014, 07:07 PM
Bob, you're a magician! There's a company in New York that would either hire you or buy you out in a minute.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
mick's D.T.I's refit - by krv3000 - 10-01-2014, 03:41 PM
RE: mick's D.T.I's refit - by b4dyc - 10-01-2014, 04:05 PM
RE: mick's D.T.I's refit - by DaveH - 10-01-2014, 04:35 PM
RE: mick's D.T.I's refit - by doubleboost - 10-01-2014, 04:38 PM
RE: mick's D.T.I's refit - by krv3000 - 10-01-2014, 04:53 PM
RE: mick's D.T.I's refit - by Micktoon - 10-01-2014, 05:28 PM
RE: mick's D.T.I's refit - by stevec - 10-01-2014, 07:07 PM
RE: mick's D.T.I's refit - by krv3000 - 10-31-2014, 03:45 PM
RE: mick's D.T.I's refit - by stevec - 11-01-2014, 01:02 PM
RE: mick's D.T.I's refit - by krv3000 - 11-01-2014, 03:35 PM



Users browsing this thread: 2 Guest(s)