MetalworkingFun Forum › Machining › General Metalworking Discussion v
Douglas shaper in slow motion

Thread Modes
Douglas shaper in slow motion
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
#5
09-30-2014, 03:47 PM
Tom, the video was only two and a half minutes long but being an old shaper hand your well familiar with the fact that time does in fact slow down and can cause spatial disorientation for the operator?
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:02 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 03:13 PM
RE: Douglas shaper in slow motion - by EdK - 09-30-2014, 03:25 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:42 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:47 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 05:45 PM
RE: Douglas shaper in slow motion - by stevec - 09-30-2014, 03:52 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:58 PM
RE: Douglas shaper in slow motion - by f350ca - 09-30-2014, 04:55 PM
RE: Douglas shaper in slow motion - by Artie - 09-30-2014, 10:14 PM
RE: Douglas shaper in slow motion - by PixMan - 09-30-2014, 10:54 PM
RE: Douglas shaper in slow motion - by Shawn - 10-01-2014, 12:59 AM
RE: Douglas shaper in slow motion - by stevec - 10-01-2014, 07:44 AM



Users browsing this thread: 1 Guest(s)