The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Douglas shaper in slow motion

Thread Modes
Douglas shaper in slow motion
Shawn Offline
Junior
****
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
The following 2 users Like Shawn's post:
DaveH (10-01-2014), big job (10-13-2014)
#1
09-30-2014, 03:02 PM




If this doesn't make you want a shaper in your shop nothing will ?. The surface finish you get with a sharp bit is amazing. 

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:


Messages In This Thread
Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:02 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 03:13 PM
RE: Douglas shaper in slow motion - by EdK - 09-30-2014, 03:25 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:42 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:47 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 05:45 PM
RE: Douglas shaper in slow motion - by stevec - 09-30-2014, 03:52 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:58 PM
RE: Douglas shaper in slow motion - by f350ca - 09-30-2014, 04:55 PM
RE: Douglas shaper in slow motion - by Artie - 09-30-2014, 10:14 PM
RE: Douglas shaper in slow motion - by PixMan - 09-30-2014, 10:54 PM
RE: Douglas shaper in slow motion - by Shawn - 10-01-2014, 12:59 AM
RE: Douglas shaper in slow motion - by stevec - 10-01-2014, 07:44 AM



Users browsing this thread: 6 Guest(s)