|
A beginner tip for turning gummy steel
|
09-27-2014, 11:43 AM
I have been using a shear tool on the lathe and my shaper for awhile now. I think the slowing the speed down was almost as big of an improvement. Now I need to give both of them a try at the same time. ?
Cheers Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
A beginner tip for turning gummy steel - by Shawn - 09-27-2014, 12:49 AM
RE: A beginner tip for turning gummy steel - by EdK - 09-27-2014, 08:07 AM
RE: A beginner tip for turning gummy steel - by f350ca - 09-27-2014, 11:00 AM
RE: A beginner tip for turning gummy steel - by EdK - 09-27-2014, 11:03 AM
RE: A beginner tip for turning gummy steel - by Shawn - 09-27-2014, 11:43 AM
|
