MetalworkingFun Forum › Machinery › Milling Machines › Mill Tooling v
Home made insert flycutter

Thread Modes
Home made insert flycutter
Dave J Offline
Sophmore
***
Posts: 183
Threads: 22
Joined: Feb 2012
Location: Australia
#10
05-10-2012, 04:58 AM
Hi Dave,
Nice work, I just have one question about the last picture. I looks like the fly cutter is on an angle to the work, was your mill not trammed?

Dave
Reply
Thanks given by:


Messages In This Thread
Home made insert flycutter - by DaveH - 04-08-2012, 06:54 PM
RE: Home made insert flycutter - by EdK - 04-08-2012, 06:57 PM
RE: Home made insert flycutter - by ETC57 - 04-08-2012, 08:32 PM
RE: Home made insert flycutter - by Wongster - 04-08-2012, 08:57 PM
RE: Home made insert flycutter - by Highpower - 04-08-2012, 10:28 PM
RE: Home made insert flycutter - by Mayhem - 04-09-2012, 12:48 AM
RE: Home made insert flycutter - by DaveH - 04-09-2012, 02:26 AM
RE: Home made insert flycutter - by Mayhem - 04-09-2012, 02:46 AM
RE: Home made insert flycutter - by doubleboost - 04-09-2012, 03:49 AM
RE: Home made insert flycutter - by Dave J - 05-10-2012, 04:58 AM
RE: Home made insert flycutter - by DaveH - 05-10-2012, 07:26 AM
RE: Home made insert flycutter - by PixMan - 05-13-2012, 08:43 AM
RE: Home made insert flycutter - by DaveH - 05-13-2012, 09:19 AM



Users browsing this thread: 5 Guest(s)