MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Lathe slotting tool

Thread Modes
Lathe slotting tool
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#13
09-22-2014, 07:35 AM
(09-22-2014, 05:50 AM)RobWilson. Wrote: Was there a reply there Chuck Chin

Rob

No, not necessary.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Lathe slotting tool - by RobWilson - 09-19-2014, 09:45 AM
RE: Lathe slotting tool - by EdK - 09-21-2014, 08:43 AM
RE: Lathe slotting tool - by chucketn - 09-21-2014, 10:44 AM
RE: Lathe slotting tool - by RobWilson - 09-21-2014, 12:39 PM
RE: Lathe slotting tool - by chucketn - 09-21-2014, 08:07 PM
RE: Lathe slotting tool - by RobWilson - 09-22-2014, 05:50 AM
RE: Lathe slotting tool - by chucketn - 09-22-2014, 07:35 AM
RE: Lathe slotting tool - by Shawn - 09-20-2014, 02:34 AM
RE: Lathe slotting tool - by chucketn - 09-20-2014, 07:12 AM
RE: Lathe slotting tool - by TomG - 09-20-2014, 04:18 PM
RE: Lathe slotting tool - by RobWilson - 09-21-2014, 03:51 AM
RE: Lathe slotting tool - by RobWilson - 09-21-2014, 03:59 AM
RE: Lathe slotting tool - by Mayhem - 09-21-2014, 06:01 AM



Users browsing this thread: 3 Guest(s)