Help wiring a 220v motor to a switch

[hermetic]

Shawn, my shaper has a set of safety switches on the doors and belt guards, all have to be closed and in place before it will start. Has it had a remote stop fitted which has been removed, but the link not put back in? If it runs ok when you push the contactor in, it could be just a burnt out coil. You need a sparky to do some basic testing, is there circuit through the overloads? have you found and pushed the reset on the overloads in case it has dropped out of latch in transit. You have done the basics right, now you need a tester with a bit more knowledge. If I was closer, I would pop in and sort it!
Phil.
UK