MetalworkingFun Forum › Machinery › Other Machinery › Shapers v
Setting stroke on Douglas Shaper

Thread Modes
Setting stroke on Douglas Shaper
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#6
09-19-2014, 11:30 PM
I was hoping to find the answer here, as I'm as lost as Shawn is on this one! I must admit, with everything else that has been going on, I've not actually had time to play with the shaper since I last posted about it.
Hunting American dentists since 2015.
Reply
Thanks given by:


Messages In This Thread
Setting stroke on Douglas Shaper - by Shawn - 09-19-2014, 03:23 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-19-2014, 03:28 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-19-2014, 04:35 PM
RE: Setting stroke on Douglas Shaper - by f350ca - 09-19-2014, 04:42 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-19-2014, 06:57 PM
RE: Setting stroke on Douglas Shaper - by Mayhem - 09-19-2014, 11:30 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-20-2014, 01:00 AM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-20-2014, 01:05 AM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 01:18 AM
RE: Setting stroke on Douglas Shaper - by dallen - 09-23-2014, 08:59 AM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 02:05 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-23-2014, 02:50 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 04:14 PM
RE: Setting stroke on Douglas Shaper - by f350ca - 09-23-2014, 04:55 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 06:04 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 06:08 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-23-2014, 06:24 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 08:00 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-23-2014, 08:05 PM
RE: Setting stroke on Douglas Shaper - by f350ca - 09-23-2014, 09:08 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-23-2014, 09:23 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-24-2014, 05:35 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-24-2014, 07:30 PM
RE: Setting stroke on Douglas Shaper - by dallen - 09-24-2014, 09:18 PM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-25-2014, 01:20 AM
RE: Setting stroke on Douglas Shaper - by dallen - 09-25-2014, 07:34 AM
RE: Setting stroke on Douglas Shaper - by Shawn - 09-25-2014, 11:50 AM



Users browsing this thread: 6 Guest(s)