Eva-Ballscrews? Feasibility study!
|
Eva-Ballscrews? Feasibility study!
|
|
There's a somewhat similar thread on another forum (Home Shop Machinist) .
 Is there any possibility of gearing the drive up to give you the required speed of linear motion with a finer pitch leadscrew?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Eva-Ballscrews? Feasibility study! - by Hopefuldave - 09-17-2014, 10:53 AM
RE: Eva-Ballscrews? Feasibility study! - by stevec - 09-17-2014, 11:18 AM
RE: Eva-Ballscrews? Feasibility study! - by Hopefuldave - 09-17-2014, 12:12 PM
RE: Eva-Ballscrews? Feasibility study! - by ScrapMetal - 09-17-2014, 04:24 PM
RE: Eva-Ballscrews? Feasibility study! - by PixMan - 09-17-2014, 05:22 PM
RE: Eva-Ballscrews? Feasibility study! - by Hopefuldave - 09-17-2014, 06:36 PM
RE: Eva-Ballscrews? Feasibility study! - by dalee - 09-21-2014, 02:43 PM
RE: Eva-Ballscrews? Feasibility study! - by Hopefuldave - 09-21-2014, 05:56 PM
RE: Eva-Ballscrews? Feasibility study! - by dalee - 09-23-2014, 08:09 PM
RE: Eva-Ballscrews? Feasibility study! - by Hopefuldave - 09-24-2014, 04:13 PM
RE: Eva-Ballscrews? Feasibility study! - by dallen - 09-24-2014, 05:46 PM
RE: Eva-Ballscrews? Feasibility study! - by Hopefuldave - 09-25-2014, 01:37 AM
|
