09-14-2014, 06:30 AM
The hub is a brand new part from Kondia, as the original was missing. I've emailed them but I've hard nothing back yet.
Previously, I did screw a long bolt into the M10x125 hole, which demonstrated that the hole is indeed off centre. From what I can tell, the hole and the key slot in the shaft are 180° from apart. When I back in the workshop I'll take another look using the method you suggest.
Previously, I did screw a long bolt into the M10x125 hole, which demonstrated that the hole is indeed off centre. From what I can tell, the hole and the key slot in the shaft are 180° from apart. When I back in the workshop I'll take another look using the method you suggest.
Hunting American dentists since 2015.