just a lil tap

Thread Modes

just a lil tap

Hawkeye Offline

Junior

Posts: 535
Threads: 39
Joined: Jan 2013
Location: Kelowna, BC, Canada

09-12-2014, 11:03 AM

Nice process, Bob. I assume the passage through the body and spigot will be pretty small - around 3 or 4mm?

Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.

« Next Oldest | Next Newest »

Messages In This Thread

just a lil tap - by krv3000 - 09-11-2014, 03:52 PM

RE: just a lil tap - by EdK - 09-11-2014, 04:13 PM

RE: just a lil tap - by kenne - 09-11-2014, 05:28 PM

RE: just a lil tap - by TomG - 09-12-2014, 07:19 AM

RE: just a lil tap - by Hawkeye - 09-12-2014, 11:03 AM

RE: just a lil tap - by krv3000 - 09-13-2014, 03:03 PM

RE: just a lil tap - by krv3000 - 09-14-2014, 04:03 PM

RE: just a lil tap - by Micktoon - 09-14-2014, 04:08 PM

RE: just a lil tap - by krv3000 - 09-14-2014, 05:15 PM

RE: just a lil tap - by RobWilson - 09-15-2014, 03:02 AM

RE: just a lil tap - by EdK - 09-15-2014, 05:08 AM

RE: just a lil tap - by krv3000 - 09-19-2014, 04:51 PM

RE: just a lil tap - by RobWilson - 09-21-2014, 05:02 AM

RE: just a lil tap - by krv3000 - 09-22-2014, 03:41 PM

RE: just a lil tap - by RobWilson - 09-22-2014, 03:44 PM

RE: just a lil tap - by krv3000 - 10-01-2014, 03:30 PM

RE: just a lil tap - by Micktoon - 10-01-2014, 05:32 PM

RE: just a lil tap - by RobWilson - 10-02-2014, 03:11 PM

RE: just a lil tap - by krv3000 - 10-02-2014, 03:41 PM

RE: just a lil tap - by RobWilson - 10-02-2014, 04:28 PM

RE: just a lil tap - by Meldonmech - 12-23-2014, 04:23 AM

Users browsing this thread: 1 Guest(s)