Before and after, drill press vise.

Hello There, Guest! Register

Thread Modes

Before and after, drill press vise.

Shawn

Offline

Junior

Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada

#6

09-11-2014, 03:36 PM

Thanks gents, if I had to guess I would say it was never used or sparingly at best. Not bad for $5.00 and a couple hours to clean it up.

Shawn

Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Before and after, drill press vise. - by Shawn - 09-11-2014, 11:23 AM

RE: Before and after, drill press vise. - by mfletch - 09-11-2014, 11:40 AM

RE: Before and after, drill press vise. - by TomG - 09-11-2014, 12:00 PM

RE: Before and after, drill press vise. - by Micktoon - 09-11-2014, 12:36 PM

RE: Before and after, drill press vise. - by doubleboost - 09-11-2014, 03:22 PM

RE: Before and after, drill press vise. - by Shawn - 09-11-2014, 03:36 PM

RE: Before and after, drill press vise. - by krv3000 - 09-11-2014, 05:01 PM

RE: Before and after, drill press vise. - by schor - 09-11-2014, 05:19 PM

RE: Before and after, drill press vise. - by PixMan - 09-11-2014, 09:36 PM

RE: Before and after, drill press vise. - by Shawn - 09-12-2014, 01:32 AM

RE: Before and after, drill press vise. - by bollie7 - 09-15-2014, 07:26 PM

RE: Before and after, drill press vise. - by stevec - 09-16-2014, 03:58 PM

RE: Before and after, drill press vise. - by Shawn - 09-16-2014, 09:26 PM

RE: Before and after, drill press vise. - by DaveH - 09-17-2014, 01:36 PM

RE: Before and after, drill press vise. - by bubby-joe - 10-16-2014, 02:24 PM

RE: Before and after, drill press vise. - by PixMan - 10-16-2014, 07:27 PM

Users browsing this thread: 3 Guest(s)