MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Extended point live centres

Thread Modes
Extended point live centres
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#12
09-10-2014, 11:06 AM (This post was last modified: 09-10-2014, 11:07 AM by DaveH.)
I thought some one on here did a post on a small rotating center. I have searched and couldn't find anything - so may be I just dreamed it Big Grin
It could have been Bob (kvr3000) refurbishing one ???
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Extended point live centres - by Mayhem - 09-09-2014, 08:16 AM
RE: Extended point live centres - by EdK - 09-09-2014, 11:42 AM
RE: Extended point live centres - by Highpower - 09-09-2014, 01:34 PM
RE: Extended point live centres - by RobWilson - 09-09-2014, 03:20 PM
RE: Extended point live centres - by doubleboost - 09-09-2014, 03:24 PM
RE: Extended point live centres - by DaveH - 09-09-2014, 06:43 PM
RE: Extended point live centres - by Highpower - 09-10-2014, 10:49 AM
RE: Extended point live centres - by Mayhem - 09-10-2014, 08:23 AM
RE: Extended point live centres - by RobWilson - 09-10-2014, 08:59 AM
RE: Extended point live centres - by Mayhem - 09-10-2014, 09:15 AM
RE: Extended point live centres - by RobWilson - 09-10-2014, 09:28 AM
RE: Extended point live centres - by DaveH - 09-10-2014, 11:06 AM
RE: Extended point live centres - by doubleboost - 09-10-2014, 03:58 PM
RE: Extended point live centres - by Dr Stan - 09-10-2014, 08:52 PM
RE: Extended point live centres - by PixMan - 09-11-2014, 06:20 AM
RE: Extended point live centres - by Mayhem - 09-11-2014, 06:35 AM
RE: Extended point live centres - by DaveH - 09-11-2014, 08:39 AM
RE: Extended point live centres - by EdK - 09-11-2014, 01:27 PM



Users browsing this thread: 7 Guest(s)