|
Vise length Stops
|
 (05-09-2012, 09:24 AM)ETC57 Wrote: I get that it's a positioning tool, but would that be for say a project requiring the reproduction of a single item? Right you are Jerry. Good for locating stock in the vice to machine multiple identical parts, or for simply placing a part back in the vice in the same spot if it was removed for measurements or a second operation, etc. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Vise length Stops - by Dave J - 05-09-2012, 02:37 AM
RE: Vise length Stops - by Mayhem - 05-09-2012, 05:01 AM
RE: Vise length Stops - by EdK - 05-09-2012, 05:57 AM
RE: Vise length Stops - by DaveH - 05-09-2012, 07:45 AM
RE: Vise length Stops - by Dave J - 05-09-2012, 09:28 AM
RE: Vise length Stops - by Highpower - 05-09-2012, 07:48 AM
RE: Vise length Stops - by DanH - 05-09-2012, 08:35 AM
RE: Vise length Stops - by ETC57 - 05-09-2012, 09:24 AM
RE: Vise length Stops - by Highpower - 05-09-2012, 10:02 AM
RE: Vise length Stops - by Dave J - 05-09-2012, 10:55 AM
RE: Vise length Stops - by doubleboost - 05-09-2012, 03:59 PM
RE: Vise length Stops - by krv3000 - 05-09-2012, 04:52 PM
RE: Vise length Stops - by ETC57 - 05-09-2012, 05:50 PM
RE: Vise length Stops - by Wongster - 05-09-2012, 06:37 PM
|
