MetalworkingFun Forum › Machinery › Other Machinery › Shapers v
Making friends with a shaper

Thread Modes
Making friends with a shaper
Sunset Machine Offline
Junior
****
Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA
#15
09-07-2014, 11:35 AM
The setscrew type looks like a good one to start with. I'm guessing that a tool intended to make small square or hex holes might be made of O2, or a bit of HSS soldered to the end of some CRS.
Reply
Thanks given by:


Messages In This Thread
Making friends with a shaper - by Sunset Machine - 07-20-2014, 09:58 AM
RE: Making friends with a shaper - by awemawson - 07-20-2014, 11:39 AM
RE: Making friends with a shaper - by Dr Stan - 07-20-2014, 12:16 PM
RE: Making friends with a shaper - by dallen - 07-20-2014, 01:37 PM
RE: Making friends with a shaper - by Artie - 07-20-2014, 06:20 PM
RE: Making friends with a shaper - by ScrapMetal - 07-20-2014, 09:03 PM
RE: Making friends with a shaper - by Hawkeye - 07-20-2014, 10:30 PM
RE: Making friends with a shaper - by stevec - 07-21-2014, 06:08 AM
RE: Making friends with a shaper - by Hawkeye - 09-07-2014, 11:07 AM
RE: Making friends with a shaper - by Sunset Machine - 09-07-2014, 11:35 AM
RE: Making friends with a shaper - by big job - 10-04-2014, 05:09 AM
RE: Making friends with a shaper - by RobWilson - 09-10-2015, 12:17 PM
RE: Making friends with a shaper - by RobWilson - 09-10-2015, 02:15 PM
RE: Making friends with a shaper - by Mayhem - 09-10-2015, 11:22 PM
RE: Making friends with a shaper - by PixMan - 09-11-2015, 06:29 AM
RE: Making friends with a shaper - by Sackett - 04-20-2016, 08:17 PM
RE: Making friends with a shaper - by Vinny - 04-20-2016, 08:21 PM
RE: Making friends with a shaper - by Dr Stan - 04-28-2016, 11:39 PM



Users browsing this thread: 5 Guest(s)