MetalworkingFun Forum › Machining › Metrology v
yet a gane a nuther d.t.i refit

Thread Modes
yet a gane a nuther d.t.i refit
Micktoon Offline
Junior
****
Posts: 638
Threads: 43
Joined: Sep 2012
Location: England
#7
08-25-2014, 05:48 PM
Another fine fix Bob and an old DTI lives to indicate again, you must be able to do these with your eyes shut now Smile

Cheers Mick.
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
yet a gane a nuther d.t.i refit - by krv3000 - 08-24-2014, 03:00 PM
RE: yet a gane a nuther d.t.i refit - by PixMan - 08-24-2014, 07:43 PM
RE: yet a gane a nuther d.t.i refit - by Mayhem - 08-25-2014, 05:24 AM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-25-2014, 01:16 PM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-25-2014, 03:31 PM
RE: yet a gane a nuther d.t.i refit - by Micktoon - 08-25-2014, 05:48 PM
RE: yet a gane a nuther d.t.i refit - by vtsteam - 08-25-2014, 07:11 PM
RE: yet a gane a nuther d.t.i refit - by dallen - 08-25-2014, 08:16 PM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-27-2014, 03:32 PM
RE: yet a gane a nuther d.t.i refit - by dallen - 08-27-2014, 05:25 PM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-29-2014, 08:47 AM
RE: yet a gane a nuther d.t.i refit - by krv3000 - 08-30-2014, 03:21 PM
RE: yet a gane a nuther d.t.i refit - by RobWilson - 08-30-2014, 03:36 PM



Users browsing this thread: 1 Guest(s)