MetalworkingFun Forum › Machining › General Metalworking Discussion v
Stepped clamps for rotary table

Thread Modes
Stepped clamps for rotary table
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#8
08-25-2014, 01:24 PM
Case hardened steel works very well for tools like that. It's strong, easy to make and wears much better than aluminum.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Stepped clamps for rotary table - by chucketn - 08-24-2014, 08:28 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 09:31 AM
RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 10:18 AM
RE: Stepped clamps for rotary table - by EdK - 08-24-2014, 10:59 AM
RE: Stepped clamps for rotary table - by TomG - 08-24-2014, 01:21 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 11:03 AM
RE: Stepped clamps for rotary table - by chucketn - 08-25-2014, 11:10 AM
RE: Stepped clamps for rotary table - by TomG - 08-25-2014, 01:24 PM
RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 04:26 PM
RE: Stepped clamps for rotary table - by EdK - 08-26-2014, 07:52 AM
RE: Stepped clamps for rotary table - by Arbalest - 08-26-2014, 07:38 AM
RE: Stepped clamps for rotary table - by TomG - 08-26-2014, 08:24 AM
RE: Stepped clamps for rotary table - by DaveH - 08-26-2014, 12:00 PM



Users browsing this thread: 4 Guest(s)