Stepped clamps for rotary table

Hello There, Guest! Register

Thread Modes

Stepped clamps for rotary table

chucketn Offline

Offline

Junior

Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN

#7

08-25-2014, 11:10 AM

I was also thinking of using aluminum plate, but steel would probably be better.

Chuck

Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Stepped clamps for rotary table - by chucketn - 08-24-2014, 08:28 AM

RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 09:31 AM

RE: Stepped clamps for rotary table - by chucketn - 08-24-2014, 10:18 AM

RE: Stepped clamps for rotary table - by EdK - 08-24-2014, 10:59 AM

RE: Stepped clamps for rotary table - by TomG - 08-24-2014, 01:21 PM

RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 11:03 AM

RE: Stepped clamps for rotary table - by chucketn - 08-25-2014, 11:10 AM

RE: Stepped clamps for rotary table - by TomG - 08-25-2014, 01:24 PM

RE: Stepped clamps for rotary table - by Arbalest - 08-25-2014, 04:26 PM

RE: Stepped clamps for rotary table - by Charles Spencer - 08-26-2014, 07:04 AM

RE: Stepped clamps for rotary table - by EdK - 08-26-2014, 07:52 AM

RE: Stepped clamps for rotary table - by Arbalest - 08-26-2014, 07:38 AM

RE: Stepped clamps for rotary table - by TomG - 08-26-2014, 08:24 AM

RE: Stepped clamps for rotary table - by DaveH - 08-26-2014, 12:00 PM

Users browsing this thread: 3 Guest(s)