05-08-2012, 07:09 AM
(05-08-2012, 06:58 AM)Wongster Wrote: Ed,
What's FHMS? Flat Head Machine Screw?
Do you loctite the long set screw for the body & handle? Looks build-able by someone with my limited skill & knowledge.
Thanks for sharing.
Regards,
Wong
Wong,
Flat head machine screw is correct.
I would Loctite the set screw to the body and handle but not to the brass face. I want that to be replaceable.
If I remember correctly, this is not entirely my design. I think I got the idea mostly from someone else's design. You can make the handle round instead of flattening it like the drawing shows. I intended to flatten it then add some wooden sides to it to make it a bit fancy.
Ed
EDIT: Added PDF of plans.
hammer_wrench.pdf (Size: 68.35 KB / Downloads: 11)